![]() Select the Default Server option from the Allocation Mode drop-down menu.A device configured for a default server will continue to receive a LAN IP address, instead of being assigned a WAN IP.Ĭonfiguring Default Server Allocation Mode Default Server mode allows the AT&T provided gateway to forward all externally initiated IP traffic (TCP and UDP protocols only) to a specified device (default host) on the LAN. Motorola gateways also include an option to use Default Server mode. Using the DHCP-fixed option is recommended. If AT&T gateway receives a different WAN IP, you will lose connectivity on your device until you manually update its settings. ![]() Note: The WAN IP, default gateway, and subnet mask the AT&T gateway is sharing are assigned to the gateway through DHCP. Manually configure your device to use the WAN IP address, default gateway, and Subnet mask provided to you by customer care.Select manual from the Passthrough Mode drop-down.Select Passthrough option from the Allocation Mode drop-down menu.Note: The device you are putting into passthrough mode must be configured to obtain an IP address through DHCP for the DHCP-fixed option to work. Enter the MAC address of the device that is to be set up to receive the public IP address in the Passthrough Fixed MAC Address field.Select DHCPS-fixed from the Passthrough Mode drop-down.Open a browser on a computer that is directly connected to the RG.If you plan to have more than one device connected directly to the ATT gateway, then using DHCP-fixed option is recommended. If the gateway is reset using this mode, the first device that makes a DHCP request will be put into passthrough mode. Note: The device you are putting into passthrough mode must be configured to obtain an IP address through DHCP for the DHCP-dynamic option to work. Typically this can be done with a power cycle of the device. Refresh the network connection on the device that is to be set up to receive the public IP address.Select Restart Now to complete the setting change.A re-starting gateway reminder message appears. Select DHCPS-dynamic from the Passthrough Mode drop-down.Select the Passthrough option from the Allocation Mode drop-down menu.Enter the Device Access Code if prompted.Select IP Passthrough below the Firewall tab.Select the Firewall tab in the RG GUI page.Open a browser on a computer that is directly connected to the gateway.To use this method, you will need to contact Customer Care to obtain your Wan IP Address, default gateway, and subnet mask. Manual: A LAN device must be manually configured with the AT&T provided device's assigned WAN IP address and gateway information.DHCPS-fixed: The public WAN IP address is delivered by the device's DHCP server to the device whose MAC address has been specified.DHCPS-dynamic: The public WAN IP address is delivered by the AT&T provided RG's DHCP server to the first device that requests a DHCP address on the LAN.The Motorola RG can be configured in three ways to pass the DHCP WAN IP address to a device on the LAN. Then connect a PC directly to the AT&T gateway with Ethernet and follow the instructions below. You will first need to locate your AT&T equipment to determine if you have a Motorola or 2Wire/Pace device. Other devices connected to your gateway may no longer be able to share files with the device in passthrough mode. When a device is configured in passthrough mode, it will be assigned a WAN IP instead of a LAN IP.Placing a device in passthrough mode will remove firewall protection provided by the AT&T gateway.Only one device can be put into passthrough mode.Note the following before configuring passthrough mode: IP Passthrough is also commonly used as an alternative to using a bridged mode. This configuration is often suitable for a customer desiring to connect third party equipment for networking, such as a router, to the AT&T provided gateway.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |